![]() ![]() New Godex models were added to printer driver distribution. Installer ends if user choose "don't install." option in Windows warning dialog. When updating drivers which have already defined their own stocks, barcode fonts or command fonts, PrnInst application failed with message box "List index out of bounds". This is fixed now.Īdded new RFID locking commands to certain printers.įixed About dialog issue with garbage after name for printers with name >= 32 chars.įixed NiceLabel crash when changing the printer on Label Setup>Printer dialog and then disabling "Use advanced printer driver interface". Print command syntax had additional parameter in case of RFID encoding and using unlock option for "User data" tag field. Now the RFID tag data are not cleared if you update the old driver with latest one.įixed issue with DNS IP resolution not working when printer network name is longer then 25 characters. Status Monitor application is also available in distribution.įollowing new printers were added to Godex printer driver distribution: MX20, RT700iW, RT730iW and BP500L.Īll new models, RT7 models and MX models are center positioned.įor Zebra RP4T ZPL, RZ400, RZ600, R110Xi4 and ZE500R models the RFID tag specifications are changed back to driver version 5.1.11 because of compatibility issue in 5.1.13. Those models support bidirectional communication. Godex driver distribution includes also advanced TCP/IP port monitor for GZPL models. Godex HD830i printer is added into NiceLabel driver. New Godex printer models supported with all three emulations (Godex, EPL, ZPL): RT863i, ZX420, ZX420i, ZX430, ZX430i, EZ520, EZ530.Ĭorrected PnP ID for EZPi-1200 GZPL, EZPi-1300 GZPL and RT730x GEPL. EZ530 GEPL/GZPL has corrected resolution to 300 dpi. Updated driver package information and driver user interface look with new branding.īZB-2 printer is using just direct thermal and not thermal transfer option.Īdded two printer models EZ6250i and EZ6350i with all three emulations. Then click "Apply".Release notes Software latest release notes Release version Uncheck the box that says "Use current Printer settings" and then in the Stop position, put in 1.06.Then go to the "Stock" tab and to the "Position Adjustments" at the bottom. ![]() On the "Page Setup" tab, make sure that the Stock is set to 3x2.then go to the "Advanced" tab and then 'Printer Defaults". ![]() When the test page prints you will hear a cutting noise and the label will fall out of the printer (NOTE the correct orientation of the label is the upper left corner with some of the left and top missing or cut off) Go back to the printer properties box and click the "Print Test Page" button
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |